Introduction to programming with labview!

The following sections are intented to give you a basic understandin of programming with LabVIEW. for each section, watch the videos. After the initial set of video's there is an exercise to do, creating a calculator. After you have done the exercize there is also a quiz you should take. Show your TA your calculator and the results of your quiz before continuing to the part 2 videos.

The exercizes and quizes will require that you have an account with NI. You should create an account when prompted using your mst.edu e-mail as your ID.

Part 1 videos

Basic environment There are 3 videos in this section.

Loops and structures There are 5 videos in this section.

Data typesThere are 4 videos in this section.

Data flowThere is 1 video in this section.

Programming toolsThere is 1 video in this section.

DebuggingThere is 1 video in this section.

help within labviewWatch the video in this section and then do the cumulative exercize linked lower on the page. After you have completed the exercise take the exam and show the results to your TA as well as your completed Calculator program.

Part 2 videos

Testing your MyDAQ Watch and follow along with the video with your own DAQ board. Note: If the video doesnt show up you may have to enable the script on the address bar!.

Programming tasks with your MyDAQThere are are a number of ways to create data acquisiton elements, these three video clips show the primay methods we will be using in this class to do this. Play these videos from top to bottom, and be sure you have installed your MyDaq card so you can create the components and practice using MAX with your board. After all 3 videos have been viewed, do the exersize shown below the third video box.